Premiere square steel studs W3/8, size 10 wrench — pack of 10
Taxes included.
Shipping costs calculated at checkout.
Square-headed studs with four flat sides and a very hard steel tip that resists wear.
✨ Key features
- ✔ Four flat sides, wear-resistant steel tip
- ✔ Galvanized steel to protect against rust.
- ✔ Designed for better grip on soft ground
- ✔ 10 mm wrench
- ✔ Box of 10
📋 Technical specifications
- Type: square-headed studs
- Wrench opening: 10 mm
- Total length: 14 mm
- Thread length: 6 mm
- Thread: W3/8
- Material: galvanized steel
- Packaging: box of 10
🐎 Why choose this product?
⚠️ The stated 10 mm refers to the wrench opening, not the head width: make sure you have a 10 mm wrench to tighten them. This model is designed for soft ground, where surface area is more important than a point. W3/8 thread, the most widely used Whitworth thread size on tapped horseshoes in Europe. ⚠️ It is not compatible with an M12-tapped horseshoe: check the thread size of your stud holes before ordering.
🧴 How to use
Clean the stud hole with a tap and then a brush before screwing in the stud: forcing a stud into a dirty stud hole can damage the horseshoe thread. ⚠️ Remove the studs as soon as the event is over and plug the stud holes: a horse that remains shod with studs in its stall, pasture, or trailer may injure itself while lying down or moving around.
